PHOENIX Evaporative Cooler, 10 hp, 19750 cu-ft/min, G40/G90 Sheet Steel, Hot-Dipped Galvanized, 51-5/8 in H x 83 in W x 49 in D
Dimensions
|
:
|
83 in W x 49 in D x 51-5/8 in H
|
- Metal skids under each dry module for roof mounting, lift brackets are supplied for lifting to installation site
- Each dry module comes with belt included
- Models IS701 requires one-wet section therefore one-pump
- Knockout for electrical service is 7/8 in
- Water supply line is 1/4 in OD and service can be from either side
- Bottom pan drain is 3/4 in male hose thread
- Configured with 8, 12 in and or hi-density 4x4 rigid media
- Bearing life - L10 bearing life of 39600 hr is based on ABMA standard 9/ISO standard 281
- Blower wheel - balanced in accordance with ISO 1940 and ANSI standard S2.19, quality grade G6.3
- 1 phase motors - tested under UL standard 507 for locked rotor and heat rise protection
- Three-phase EISA motors are NEMA MG-1 table 12-12 compliant
- Evaporative media - specially corrugated cellulose material, impregnated with insoluble anti-riot salts and rigidifying saturates
- Sealant - water immersion per ASTM D870
- Flexibility - per ASTM D756 and ASTM D522
- Corrosion-resistance - per ASTM B117
- Pencil hardness - per ASTM D3363
- Impact-resistance - per D2794
- Surface burning characteristics - of building materials (best rating) per UL 723 and ASTM E-84
- PEBLAR XT - is our one coat TGIC polyester powder-coating system that is applied over five-stage zinc phosphate prepared sheet steel surfaces for protection against atmospheric corrosion
-
Specification Sheet
https://assets.unilogcorp.com/267/ITEM/DOC/Phoenix_IS500_Specification_Sheet.pdf